Front & Rear U-Joint Assembly 25mm/43.6mm Int. Snap Ring 19-1001 Category_Engine Main Bearings & Seals All load bearing points are

All load bearing points are flag-stitched for maximum strength and the thread used is marine-grade to prevent it rotting if left damp and in case it comes into contact with salt water

Flywheel Puller Specifications

A J-hook and carabiner clip provides a secure mount and are complete with a rubber coating to prevent any scratching of paintwork

Output: 12VDC 2A

a slick and minimal design to match every bike

Front & Rear U-Joint Assembly 25mm/43.6mm Int. Snap Ring 19-1001 Category_Engine Main Bearings & Seals All load bearing points areA quality ATV UTV U Joint assembly from All Balls. Features: Cold forged from SCM 415 steel, precision ground journals are case hardened to HRC58 61. U Joints are pre greased with hi temp Lithium Complex 3 grease. Bearing cups feature a Quad lip seal to keep contamination out and grease in. Centrally located grease zerk and grease channels in bearing cup evenly distribute grease. Kits include cap plug to eliminate grease zerk for low clearance